IMPORTANT NOTE PRIOR TO INSTALL: With some hardware configurations, x360Recover will automatically start the install without any prompts. This will delete all data on the drive that you are using to install x360Recover. Therefore, do not boot a machine with the x360Recover installer that has data on it that you intend to keep.
NOTE: An Internet connection from the appliance will be required during the post-installation provisioning of the device.
The following steps describe the installation of the underlying x360Recover operating system.
- In order to ensure that the installation can complete successfully, the system should be connected to a network with DHCP and open Internet access to allow the software to be updated and registered during the Setup & Configuration process.
- If booting from a USB device, it may be necessary to change the default boot order of the system.
- Power on the system and press the appropriate key (Typically <Del>, <F1> or <F2> on most white-box systems, or <F9> on HP Servers) to enter the BIOS setup menu.
- Locate the Boot Order management page within the BIOS and configure the system to enable booting from USB Flash drive.
- Ensure that the boot order places the USB device before internal Hard Drives. Alternatively, press the Boot Menu key (Typically <F9>, <F10>, or <F11> on most systems) and directly select the USB device to boot from.
NOTE: The x360Recover operating system does not support booting from motherboard (fake) RAID controllers which require Windows-only drivers.
If your hardware defaults to booting using RAID, then you must change the settings within the BIOS to boot using SATA or AHCI mode.
Consult your system motherboard documentation for instructions on selecting between RAID and SATA/AHCI boot modes.
Once the BIOS configuration has been completed:
- Ensure that the DVD or USB Flash Drive is inserted into the system.
- Exit from the BIOS after saving any settings changes.
- Reboot the machine.
The x360Recover installer should now load on the system.
- Boot the x360Recover OS.
- When prompted for an Installation Type, select Erase Everything and Install x360Recover.
IMPORTANT NOTE #1: If any other operating system is installed on the system, it will be destroyed, and replaced with the x360Recover operating system.
IMPORTANT NOTE #2: If prompted "Do you want to wipe disk and install Encrypted?", select the option of not doing so. If you encrypt the OS drive, any time the BDR reboots, you will need to enter the encryption key from the device.
3. Click the Continue button to proceed with the installation
4. Select the first disk (typically”sda”) in the system to be the boot drive and operating system disk.
NOTE: This disk will be formatted and erased during the installation.
5. Click on Install Now to continue.
Installation will now proceed; please wait for this step to fully complete. Loading the operating system may take several minutes, depending on the hardware and type of USB installation media being used.
6. When the installation is complete, remove the DVD or USB Flash Drive from the system.
7. Click the Restart Now button.
NOTE: Depending on your system BIOS, it may be necessary to press the <Space> bar once to continue if the reboot appears to be stalled.